BMW Halo Bulb Replacement
Materials Required
- Flathead Screwdriver
- 10MM Socket/Wrench
Disconnect Battery
Disconnect the vehicle's battery to ensure safety while conducting this job.
Remove Halo Bulb Cover
Remove the halo bulb cover by pressing in the two retention tabs then slide it out of place.
Loosen Halo Bulb
Loosen the halo bulb by twisting counterclockwise (downward) until it can be backed out by hand.
Remove Halo Bulb
Once the halo bulb is fully loosened, simply remove the bulb out from the headlight assembly.
Unplug Halo Bulb Connector
Unplug the halo bulb connector by prying the two side-clips outward and pulling the connector apart.
Install New Halo Bulb
Install the new halo bulb in place on the headlight assembly.
NOTE: be careful not to directly touch the bulb(s) itself.
Tighten Halo Bulb
Tighten the halo bulb into place by twisting clockwise (upwards).
Re-Install Halo Bulb Connector
Re-install the halo bulb connector by pressing the two sides of the connector together until it clicks.
Neatly Route Halo Wiring
Neatly stow away all of the wiring associated with the halo bulb, to ensure a tidy area that will be free of future issues.
Re-Install Halo Bulb Cover
Re-Install the halo bulb cover by sliding it back into place and pressing it down until it clicks into place.
DIY Complete!
Good job replacing your faulty halo bulb! Be sure to keep an eye on your electrical system for any future issues.